|
|
- "X"
Back Harness
- Designed
for speed and reliable comfort. The X-back design keeps the harness
in place, controls vertical motion, but doesn't restrict the dog's gait.
The "Sliding X" on top allows the harness to
compensate for different dogs, and for the off-center pull of standard
gangline hitches.
- Padded
with Polar Fleece
- Available
in red or blue
$18.00
|

How
to measure your dog for a harness
You must get your part number here
before ordering your harness |
- Freight/Weight
Pull Harness
-
This traditional singletree harness is used for weight pulling, sledding,
and heavy-duty hauling. Frequently it is used in wheel position (near
the sled) because the low-draft hitch is more level with the gangline.
The harness comes with a hardwood spreader kit, which you cut to the
exact width of your dog. The spreader bar should be touching the rear
of the dog when the harness is in a relaxed position. Put the screws
(provided with harness) through the fabric and into the pre-drilled
spreader bar. The height of the hitch is adjustable, so the load is
always held in place for maximum pull. The hitch ring uses limited side
slip to compensate for off-center loads, and the backstraps feature
the same "sliding X" as the X-back harness.
- Padded
with Polar Fleece
- Available
in red or blue
$32.00
|

How
to measure your dog for a harness
You must get your part number here
before ordering your harness |
- Adjustable
Puppy Harness
- 3/4" webbing
in red or blue
- Fully adjustable
neck and length
- Should be used
for training only
- Does not have padding
- Available
in red or blue
$16.00
|

Adult
harness shown, but they are similar |